Bits n pieces are a forming

Berti44 · Post by **Berti44** » Sun Sep 23, 2018 6:24 pm

Owned for 2 years and the rebuild now begins.

Berti44 · Post by **Berti44** » Sun Sep 23, 2018 6:26 pm

Berti44 · Post by **Berti44** » Sun Sep 23, 2018 6:27 pm

Berti44 · Post by **Berti44** » Sun Sep 23, 2018 6:29 pm

Berti44 · Post by **Berti44** » Sun Sep 23, 2018 6:33 pm

New stem taper roller bearings fitted.

Berti44 · Post by **Berti44** » Sun Sep 23, 2018 6:39 pm

Now to rebuild forks. I’ll

Nito · Post by **Nito** » Fri Sep 28, 2018 3:17 pm

Great to see the frame like that, looks like you're doing a cracking job of restoring that.

Nice to see the Abba Skylift working on it, I just recently bought a skylift (June!) but haven't got around to trying the Katana on it yet so nice to know it's compatible!

I doff my hat to you

Kryten · Post by **Kryten** » Fri Sep 28, 2018 3:42 pm

Nice one.

Don't forget to fit the airbox before the engine....

Berti44 · Post by **Berti44** » Fri May 15, 2020 4:02 pm

Thanks Kryten for the tip about the airbox invaluable

My tip to other folk is to make sure you put the rear brake shaft in/on before fitting the swing arm. Yep my bad

Berti44 · Post by **Berti44** » Fri May 15, 2020 4:09 pm

Lockdown progress is steady: this photo was taken before I had to remove the swing arm again.

Katana Owners Club U.K.

Bits n pieces are a forming

Bits n pieces are a forming

Re: Bits n pieces are a forming

Re: Bits n pieces are a forming

Re: Bits n pieces are a forming

Re: Bits n pieces are a forming

Re: Bits n pieces are a forming

Re: Bits n pieces are a forming

Re: Bits n pieces are a forming

Re: Bits n pieces are a forming

Re: Bits n pieces are a forming