Page 1 of 2
What tail section is this?
Posted: Fri Dec 11, 2020 6:56 pm
by Bikeazoid
Hi, I was checking out the pix and saw this yellow Kat with a different tail section.
Question, what is this? I really like the rolled leather (or not) seating.
Re: What tail section is this?
Posted: Fri Dec 11, 2020 7:09 pm
by Smallkat
it's either a tasteless mess, or a design masterstroke. I can't quite decide.
Re: What tail section is this?
Posted: Fri Dec 11, 2020 7:19 pm
by Lexdba
Smallkat wrote: ↑Fri Dec 11, 2020 7:09 pm
it's either a tasteless mess, or a design masterstroke. I can't quite decide.
It’s absolutely shaite.
Re: What tail section is this?
Posted: Fri Dec 11, 2020 8:52 pm
by Kryten
That’s a Speer body kit on a Kat. German accessory company.
The paint job can make it, or not...
Re: What tail section is this?
Posted: Fri Dec 11, 2020 8:55 pm
by Pedda
Not Speer but Gimbel.
Re: What tail section is this?
Posted: Fri Dec 11, 2020 9:00 pm
by Pedda
This is how it looked like in full armor.
Re: What tail section is this?
Posted: Fri Dec 11, 2020 9:02 pm
by Kryten
Pedda wrote: ↑Fri Dec 11, 2020 8:55 pm
Not Speer but Gimbel.
Ah yes. Sorry! Well spotted Pedda!
I’ll put it down to too many Brewdog “Barnard Castle” Hazy IPA’s
Re: What tail section is this?
Posted: Fri Dec 11, 2020 9:36 pm
by Smallkat
Pedda wrote: ↑Fri Dec 11, 2020 9:00 pm
This is how it looked like in full armor.
Screenshot_20201211-215756.jpg
It's not so bad in that picture. But I have had a large Amaretto with a malt chaser.
Re: What tail section is this?
Posted: Fri Dec 11, 2020 10:15 pm
by Bikeazoid
Does anyone know where to get this tail? Or even the plans to make it in a 3D printer?
Re: What tail section is this?
Posted: Sat Dec 12, 2020 10:06 am
by Pedda
That's the Ikon Kat prototype. Only chance to make yourself a one off copy thing, I'm afraid.