Page 1 of 3
Rotor Removing tool
Posted: Sat Mar 05, 2011 4:02 pm
by JACKJABBA
Hi Guys,
does anyone know what size rotor removal tool I need to get the rotor off on my 1100 engine
Does the club have one
Regards Jack
Re: Rotor Removing tool
Posted: Sat Mar 05, 2011 6:17 pm
by JACKJABBA
Looks like m30 x 1.5 RH
Re: Rotor Removing tool
Posted: Sat Mar 05, 2011 6:23 pm
by bobster
we are working on it............just sent one i borrowed to Fossie.
you're not a Club member though!
Re: Rotor Removing tool
Posted: Sat Mar 05, 2011 6:28 pm
by JACKJABBA
Yes I am.
Just forgot my KOC number
Does this look ok, as I don't mind buying one.
http://www.priceninja.com/Editorial/fly ... 8736-p.asp
Re: Rotor Removing tool
Posted: Sun Mar 06, 2011 9:17 am
by Pedda
Re: Rotor Removing tool
Posted: Sun Mar 06, 2011 9:21 am
by Pedda
Re: Rotor Removing tool
Posted: Sun Mar 06, 2011 9:34 am
by JACKJABBA
Thanks Pedda. I will buy one and donate it to the club when I have rebuilt my engine.
Cheers Jack
Re: Rotor Removing tool
Posted: Sun Mar 06, 2011 10:04 am
by sparki
That link ya posted seems a good price for one ... Pop your membership number iqn your sig ... Easier to recognise who's who
Re: Rotor Removing tool
Posted: Sun Mar 06, 2011 11:47 pm
by fossie
we have a 1100 tool that belongs to a member , the 1 needed is a pop up , However bobster aquired 1 from the trade , BUT doesn't do it. The thread isn't long enough and they correct tool should have a taper it looks like.
So drawing board stge for that one then .
Bobster will get it back asap. Cheers anyway and thank the trade lads for their help.
Re: Rotor Removing tool
Posted: Mon Mar 07, 2011 12:33 pm
by bobster
Cheers
Can you make sure you put a return address ( sender) in case it gets lost and then has to go to the "Raiders of the lost Arc hanger" Never to be seen again just like my chain oiler!