Page 1 of 1
550 Dimension please
Posted: Fri Feb 22, 2013 10:47 pm
by Nigelkat
Hi 550 owners. If you have seen my Café Kat project you may of noticed that there are no seat locating brackets on the frame top rails.
The frame was generally pretty cut up and dubious bits added before I got hold of it.
What I need is the dimension from the centre of the rear tank mounting holes to the back of the locating brackets on the frame top rail.
Many thanks
Nigel
Re: 550 Dimension please
Posted: Sat Mar 02, 2013 9:49 pm
by Nigelkat
Bump
any 550 owners poping out to the garage this weekend
Re: 550 Dimension please
Posted: Sat Mar 02, 2013 9:53 pm
by callyboy
Ooops. Sorry Nigel. Forgot. Will have a look tommoz when i can.
Cheers
Pete
Re: 550 Dimension please
Posted: Sun Mar 03, 2013 1:45 pm
by callyboy
50 from centre of bolt to back of plate.OK?
Pete
Re: 550 Dimension please
Posted: Sun Mar 03, 2013 9:32 pm
by Nigelkat
Opps sorry Pete not that one its the 1 in the pic below
Cheers
Nigel
Re: 550 Dimension please
Posted: Sun Mar 03, 2013 9:53 pm
by callyboy
ok. Tomoz.
Pete
Re: 550 Dimension please
Posted: Mon Mar 04, 2013 2:50 pm
by callyboy
2cm (is that right? mm are ther little buggers right?)
Pete
Re: 550 Dimension please
Posted: Mon Mar 04, 2013 8:41 pm
by Nigelkat
Cheers Pete, looks bout right. yeah mm are the little buggers that I can`t see anymore. old age and all that.